SERDIA EMR2 ERROR TABLE 20-292 After a delay time - fill limitation. Check engine (oil level, oil pump). Check oil pressure sensor and cable. Check oil pressure warning line characteristic. Check coolant. Check coolant temperature sensor and cable. Check charge air. Check charge air temperature sensor and cable. Check coolant level. Check coolant level sensor and cable. Check parameters. Check speed settings (21). Check PID setting. Check rods. Check actuator and replace if required. Check cable to actuator. Check speed sensor (impulses on incorrect speed). Check no. of teeth. For vehicles check for possible thrust mode. Check fuel. Check fuel temperature sensor and cable.
Fault message (disappears when oil pressure is again above recovery limit). Fault message (disappears when coolant temperature again drops below recovery level). After a delay time - fill limitation. Fault message (disappears when charge air temperature again drops below recovery level). After a delay time - fill limitation. Fault message. See Chapter 4.3.3 Excess speed protection. Fault message (disappears when fuel temperature again drops below recovery level). Oil pressure below speed-dependent warning line characteristic Coolant temperature has exceeded warning level. Charge air temperature has exceeded warning level. Switch input “Low coolant level” is active.
Revolution was/is above (top) revolution speed limit. “Thrust mode” function is active. Fuel temperature has exceeded warning level. 1 2 3 5 6 7 3 3 3 3 3 3 2 2 2 2 2 2 Oil pressure warning Coolant temperature warning Charge air temperature warning Coolant level warning Speed warning (with thrust mode operation). Fuel temperature warning 30 31 32 34 35 36 Functional fault warning Guasti funzionali, avvertenza