Deutz — 8.2 EMR1

SERDIA WHAT TO DO IF...? 8.2.5 ENGINE DOES NOT START 20-310 Indication Possible cause Remedy Starter speed > 160 r.p.m. not reached. Check using multimeter: terminal voltage at starter Replace battery. Clean earth wire connections. Starter speed ok, fuel rack tra-vels to start position. Faulty fuel supply. Restore fuel supply. Starter speed ok, fuel rack stays at zero position. No power supply, connected to wrong pins or incorrect polarity. Shutoff solenoid defective or not connected. Fuel rack stiff. Speed sensor faulty. Starting fuel charge limitation is set too low or coolant temperature is too high for the EMR. Remove vehicle connector and check for correct connections:

Pin 14F=+Ubatt Pin 1F=-Ubatt Pin 2F=-Ubatt Locate site causing stiffness and remedy as appropriate. Replace sensor, check plug connection and line. Using SERDIA check measured value “(M9)coolant temperature” in the menu “current measured values”. Flashing pilot light. There is a serious fault in the EMR system. You should remedy the fault before attempting any further starts. Locate error using SERDIA. SERDIA error message: ”8405: Actuator (positioner, travel meter, fuel rack)”. Identification of fuel rack travel deviation, measured value in shutdown range. Shutoff solenoid defective or not connected. Replace actuator, see service example, actuator replacement.

Additional setting is not necessary. SERDIA error message: ”8170:(M13)Speed 1, camshaft”. Short circuit or interruption on the speed sensor (camshaft sensor) or supply line or plug connection. Replace sensor, check plug connection for contamination or corrosion, check lines be- tween vehicle plug and sensor for damage. SERDIA error message: ”8210:Data loss EEPROM” ”8220:Data loss coil data” ”8020:ECU (positioner actuation)” Memory error in the EMR Memory error in the EMR ECU Failure Replace ECU. Transfer data from old ECU to the new one “1:1”. SERDIA error message: ”8160:(M21)OilPressure Sensor” Oil pressure measured value (M21) lies outside permitted range, also with engine switched off.

Replace sensor, check plug connection for contamination or corrosion, check lines be- tween vehicle plug and sensor for damage. SERDIA error message: ”8140:(M9)CoolantTemp Sensor” Coolant temperature measured value (M9) lies outside the permitted range, also with engine switched off. Replace sensor, plug and line control SERDIA error message: ”8120:(F24)Acceler Pedal(SWG1)” Accelerator pedal sensor incorrectly calibrated. Check calibration values in the menu “Calibration” and change if necessary.