Deutz — 8.2 EMR1

SERDIA WHAT TO DO IF...? 8.2.8 CONTROL UNIT REPLACEMENT The control unit can be replaced in two ways: 1. When the control unit is damaged, but the data are still readable (communications with SERDIA are possible). 2. A new control unit is installed with engine data set programmed at the factory. General overview of EMR1 control units 1) Current Part No., supplied if ordered. General overview of EM2 control units Notes on the entries above: 20-313 1012/1013/2013 1015 1012/1013 for Deutz-Fahr only - With MN label - Programmed -SERPIC Part No. - Without MN label - Not programmed -Part No. on control unit - With MN label - Programmed -SERPIC Part No. - Without MN label - Not programmed -Part No.

on control unit - With MN label - Programmed -SERPIC Part No. - Without MN label - Not programmed -Part No. on control unit 0211 2016 0211 2017 0211 2016 0211 2017 0211 2451 0211 2088 See also: SM 130-99-9305 Replaced by Replaced by 0211 2581 0211 2570 See also: SM 130-27-9308 Replaced by 0422 6179 Replaced by 0422 6178 Replaced by Replaced by 0211 2580 0211 2571 See also:

SM 130-27-9308 Replaced by Replaced by Replaced by Replaced by Replaced by Replaced by 0211 26911 1) 0211 2686 1) 0419 4043 1) 0419 9995 1) 0211 2692 1) 0211 2690 1) All model series - With MN label - Programmed - SERPIC Part No - Without MN label - Not programmed - Part No.on control unit 0211 2704 0211 2850 - With MN label - Programmed - SERPIC Part No. - Without MN label - Not programmed - Part No.on control unit The completed control unit. To be able to operate with the engine, each control unit must be programmed with the specific data set for the engine (it has a label with the engine number attached). In this way, the engine and control unit together form an integrated unit.

Therefore, when ordering a new control unit, the engine number (MN) is indicated along with the engine model. Control units are completed by DEUTZ. Unprogrammed control unit. The engine cannot be started with this control unit. For reconditioning operations, this control unit can be completed by transferring the specific engine data set from the 'old' control unit, using SERDIA Level III. See also SERDIA Manual "Complete programming". For reconditioning purposes, this means that unprogrammed control units can also be or- dered from DEUTZ Service partners (Competence Class II). They are then completed (with the MN label) by the service partner.

If the data set cannot be read from the 'old' control unit, this can be requested by Email in the same way, as described in SM 0199-99-9287 ‚ "Confirming modifications to EMR data".