4WD PROPELLER SHAFT 15 - Separate the flanges, lower the jack “ D “and withdraw the shaft (20) towards the front of the tractor. 2 D 20 F0078483 Refitting Refitting is the reverse of removal. 1 Tighten the nuts in a cross-wise sequence. Nuts: 43.5±10% Nm (32±10% lb.ft.) 2 Rear coupling: Grease 1 - Start the engine and engage the front suspension by pressing the relative button in the cab. 2 - Wait a few seconds and then disengage the front sus- pension. 3 - Repeat this operation a number of times to purge the air from the system. 4 - Stop the engine, check the oil level and top up if nec- essary. 30-71