5. After the preheat completion, immediately turn starter switch to (START) position (Figure 11). Engine " " O I should start in approximately five (5) seconds. WARNING AVOID DEATH OR SERIOUS INJURY If the engine does not start after approximately fifteen seconds of cranking, release the starter switch. Wait about five (5) minutes and repeat above steps. FG018149 Figure 11 6. After engine has started, release key. Key will return to "I" (ON) position (Figure 11). 7. After the engine starts, check all operating indicators to make sure that all engine systems (oil pressure, coolant, etc.) are in the normal operating range. If any problems are noticed, stop engine. 8.
Follow "Hydraulic System Warm-up" procedures in this section. (See page 3-12) DX225LC-3 Operation 3-8