3. Operation While the battery disconnection switch is "ON", the engine coolant heater can be started-up by the following modes: A. Manual mode: The operator operates the heater by switching "ON/OFF" directly. Pressing the ( ) button turns on the heater, and pressing it once again will turn it off. B. Auto mode: The heater turns on or off at preset time. Pressing the ( ) button will make the program number blink. Set up the starting time using the left ( ) or right ( ) button. Keep press the ( ) button to set up program numbers 2 and 3, or switch to time mode. C. Operating mode: The heater will operate for desired time. With the heater off, press the left ( ) button for 3 seconds.
While the operating time is blinking, set up the desired operating time using the left ( ) or right ( ) button. (10 - 120 minutes). D. Residual time setting While the heater is operating, set up the required residual time using the left ( ) or right ( ) button. (1 - 120 minutes). 4. Digital timer error code If there is a problem in the engine coolant heater, the digital switch will display an error code. Call the nearest service center and inform the center of the error code.
DX225LC-3 Operation 3-10 Error Code (Digital Timer) Description F 00 Control unit error F 01 Failure to operate (after 2 successive trial for starting) F 02 Ignition failure (3 or more failures) F 03 Over or under current F 04 Early flame detected F 05 Combustion monitor broken or short-circuited F 06 Temperature sensor line broken or short-circuited F 07 Fuel pump line broken or short-circuited F 08 Fan motor line broken, short-circuited, overloaded, or blocked F 09 Ignition plug line broken or short-circuited F 10 Overheated F 11 Circulation pump line broken or short-circuited