Starting Engine With a Booster Cable WARNING AVOID DEATH OR SERIOUS INJURY 1. An explosive gas is produced while batteries are in use or being charged. Keep flames or sparks away from the battery area. 2. Charge batteries in a well ventilated area. 3. Always wear eye protection when starting a machine with jumper cables. HAOA440L Figure 14 4. Improper jump-starting procedures can cause an explosion resulting in death or personal injury. 5. Jump-start vehicles on dry ground or concrete. Do not jump-start the machine on a steel floor because the floor is always grounded. 6. When starting from another machine, make sure the machines do not touch. 7.
Always connect the auxiliary battery positive (+) terminal to the depleted battery positive (+) terminal first. Then connect the auxiliary battery negative (-) terminal to the frame of the depleted battery machine second. 8. Connect positive cables first when installing cables and disconnect the negative cables first when removing. IMPORTANT The machine has a 24V (-) negative ground electrical system. Use the same capacity 24V booster batteries when jump-starting engine. If the batteries are drained during starting procedures, jump-start engine using auxiliary or booster batteries according to the following procedure: Connecting Booster Batteries 1.
Stop engine before booster batteries (3, Figure 15) are mounted. 1 RED 2. Connect one end of red cable (1, Figure 15) to the positive (+) terminal of the machine batteries (4), and the other end to the positive (+) terminal of the booster batteries. 3. Connect one end of black cable (2, Figure 15) to the negative (-) terminal of the booster batteries (3), and then make ground connection to the upper frame (5) of the machine to be started with the other end of black (-) cable (2, Figure 15). 3 BLACK 4 2 5 ARO0440L Figure 15 Operation 3-11 DX225LC-3