2. Move safety lever (Figure 17) to "UNLOCK" position. Unlock EX1300566 Figure 17 Lock 3. Slowly cycle boom, arm and bucket cylinders about five times without a load to circulate the oil through the system. Do this for five (5) minutes. 4. Check for clearance and fully raise the front attachment. Swing clockwise three (3) revolutions. Swing counterclockwise three (3) revolutions. 5. Travel forward and reverse at low speed for two (2) revolutions of the drive sprocket. Figure 18 FG018384 Hydraulic System Warm-up – Cold Weather 1. Run engine at "LOW IDLE" (no load) for five (5) minutes (Figure 19). Figure 19 FG018148 2.
Run engine for approximately five (5) minutes set at the middle of the speed range, without a load (Figure 20). FG018151 Figure 20 Operation 3-13 DX225LC-3