Doosan DX225LC-3 — Operation in Rainy or Humid Conditions

Operation in Dusty and Sandy Areas Operation of machine can cause dust in almost any area. However, when in predominantly dusty or sandy areas, additional precautions must be taken. 1. Keep cooling system fins and cooling areas clean. Blow out with compressed air, if possible, as often as necessary. WARNING AVOID DEATH OR SERIOUS INJURY Wear goggles when using compressed air to prevent face or eye injury. 2. Use care when servicing fuel system to prevent dust and sand from entering tank. 3. Service air cleaner at frequent intervals, check air restriction indicator daily and keep dust cup and dust valve clean.

Prevent dust and sand from entering engine parts and compartments as much as possible. 4. Lubricate and perform services outlined on current lubrication chart on machine and Lubrication Chart and Table. Section 4. Clean all lubrication fittings before applying lubricant. Sand mixed with lubricant becomes very abrasive and accelerates wear on parts. 5. Protect machine from dust and sand as much as possible. Park machine under cover to keep dust and sand from damaging unit. Operation in Rainy or Humid Conditions Operation under rainy or humid conditions is similar to that as in extreme heat procedures previously listed. 1. Keep all exposed surfaces coated with preservative lubricating oil.

Pay particular attention to damaged or unpainted surfaces. Cover all paint cracks and chip marks as soon as possible to prevent corrosive effects. DX225LC-3 Operation 3-72