Operation in Saltwater Areas Saltwater and saltwater spray is very corrosive. When operating in or around saltwater areas, or in or around snow, observe the following precautions: 1. When exposed to saltwater, dry machine thoroughly and rinse with freshwater as soon as possible. 2. Keep all exposed surfaces coated with preservative lubricating oil. Pay attention to damaged paint surfaces. 3. Keep all painted surfaces in good repair. 4. Lubricate machine as prescribed on lubrication chart on machine or Periodic Service Table and Chart, Section 4, in this manual. Shorten lubricating intervals for parts exposed to salt water. 5.
Check operating controls to ensure proper functionality and that they return to "NEUTRAL" when released. Operation During Electrical Storms During electrical storms, do not enter or exit machine. If you are off machine, keep away from machine until storm passes. If you are in cabin, remain seated with machine stationary until storm passes. Do not touch controls or anything metal. Operation at High Altitudes Operation instructions at high altitudes are the same as those provided for extreme cold. Before operating at high altitudes, engine fuel and air mixture may have to be adjusted according to appropriate engine manual. 1. Check engine operating temperature for evidence of overheating.
The radiator cap must make a perfect seal to maintain coolant pressure in cooling system. Perform warming-up operation thoroughly. If machine is not thoroughly warmed up before control levers or control pedals are operated, reaction of machine will be slow. If battery electrolyte is frozen, do not charge battery or start engine with a different power source. There is a potential hazard that could cause a battery explosion or fire. Before charging or starting engine with a different power source, thaw battery electrolyte and check for any leakage of electrolyte before starting. Operation 3-73 DX225LC-3