Equipment Lowering with Engine Stopped To lower the boom, place the hydraulic lockout lever in the "UNLOCKED" position and turn starter switch to "I" (ON) position. Move the joystick to "BOOM LOWER" position. If the accumulator is still charged, the boom will lower. Turn key to "O" (OFF) position and remove from starter switch. If the boom does not lower, the accumulator is empty. Use one of the following methods to lower the boom. Machine Without a Boom Lowering Control Valve WARNING AVOID DEATH OR SERIOUS INJURY Boom weight can cause cylinder oil pressure to reach relief pressure of the boom lowering control device when the boom is supported by one cylinder.
Boom can lower suddenly, causing death or serious injury. To avoid death or serious injury, be sure no one is under or near the work tool before manually lowering the boom. Keep all personnel and bystanders away from the boom area when lowering the boom with the engine stopped. When you must manually lower the boom if the engine has stopped and cannot be started, use the following procedure: 1. Relieve the pressure in the hydraulic system before manually lowering the boom. A. Turn starter switch to "I" (ON) position. B. Move the hydraulic lockout lever to "UNLOCKED" position. C. Move the joysticks and travel levers/pedals forward and backward to relieve accumulator pressure D.
Turn key to "O" (OFF) position and remove from starter switch. 2. Allow hydraulic oil to cool. Tip breather cap up (1, Figure 141) on the top of the hydraulic tank until internal pressure in the hydraulic tank has been completely relieved. 1 Figure 141 FG020062 DX225LC-3 Operation 3-74