Machine With a Boom Lowering Control Valve WARNING AVOID DEATH OR SERIOUS INJURY Boom weight can cause cylinder oil pressure to reach relief pressure of the boom lowering control device when the boom is supported by one cylinder. Boom can lower suddenly, causing death or serious injury. To avoid death or serious injury, be sure no one is under or near the work tool before manually lowering the boom. Keep all personnel and bystanders away from the boom area when lowering the boom with the engine stopped.
When you must manually lower the boom if the engine has stopped and cannot be started, or the hydraulic system is disabled, the operator can still lower the boom, using the following procedure, when machine is equipped with a boom lowering control valve. 1. Relieve the pressure in the hydraulic system before manually lowering the boom. A. Turn starter switch to "I" (ON) position. 1, 2 B. Move the hydraulic lockout lever to "UNLOCKED" position. C. Move the joysticks and travel levers/pedals forward and backward to relieve accumulator pressure. D. Turn key to "O" (OFF) position and remove from starter switch. Figure 144 FG019863 2. Loosen locknut (1, Figure 144) of the lock valve. 3.
Slowly turn check valve (2, Figure 144) counterclockwise until check valve stops. The boom will lower to the ground. 4. Make sure that work tool has been completely lowered onto the ground. Tighten check valve (2, Figure 144). 5. Tighten locknut (1, Figure 144) to a torque of 0.23 ± 0.03 kg•m (2.25 ± 0.25 Nm, 1.66 ± 0.18 ft lb). After completion of the manual boom lowering, make necessary repairs before you operate the machine again. NOTE: For additional information, contact your DOOSAN dealer. DX225LC-3 Operation 3-76