Check Level of Hydraulic Oil Tank WARNING AVOID DEATH OR SERIOUS INJURY The hydraulic oil will be hot after machine operation. Allow system to cool before attempting to service any hydraulic components. The hydraulic tank is pressurized. Tip breather cap up slowly to allow the pressurized air to vent. After the pressure has been released, remove service covers. ARO1760L Figure 14 1. Park machine on firm and level ground. Lower boom and position bucket on ground as shown in Figure 15. 2. Move engine speed to "LOW IDLE". EX1300541 Figure 15 3. Move safety lever to "LOCK" position. 4. Have a second person, check hydraulic oil level gauge by opening right access door.
Oil level must be between marks on sight gauge. H L Figure 16 FG020182 5. If the level is below "L" mark add oil. A. Stop engine. B. The hydraulic tank is pressurized. Tip breather cap up slowly to allow the pressurized air to vent. C. Remove upper cover of the hydraulic tank and add oil. FG020183 IMPORTANT Do not fill above "H" mark on sight gauge. Overfilling can result in damage to equipment and oil leaking from hydraulic tank because of expansion. Figure 17 Inspection, Maintenance and Adjustment 4-25 DX225LC-3