DX225LC-3 Inspection, Maintenance and Adjustment 4-30 Clean Dust Net in Front of Oil Cooler and Intercooler IMPORTANT If running excavator in dusty area, check dust net everyday and clean it if dirty. FG0194 WARNING Figure 27 AVOID DEATH OR SERIOUS INJURY If using compressed air or water to clean the dust net, wear safety goggles for proper eye protection. 1. Loosen wing bolt(s) and remove dust net. 2. Clean with compressed air or water. Check Cooling System and Refill as Required WARNING FULL K"ISFE UCELOPL CADON.OD L LLAONW OT" L WEVH WEELN BEENTGWINEEEN L AVOID DEATH OR SERIOUS INJURY Allow the engine to cool before releasing the radiator cap.
Loosen the cap slowly to release any remaining pressure. FG0194 Radiator cleaning is performed while the engine is running. Figure 28 Lock out and tag the controls alerting personnel that service work is being performed. Do not remove radiator cap unless it is required. Observe the coolant level in the coolant recovery tank. NOTE: Do not mix ethylene glycol and propylene glycol antifreeze together. 1. When the engine is cold, remove radiator cap and check the coolant level inside the radiator. Do not rely on the level of coolant in the coolant recovery tank. Refill radiator as required. Refer to coolant concentration table. (See page 4-94) 2.
Check to make sure that coolant transfer line from the coolant recovery tank to the radiator is free and clear of obstructions, or is not pinched. 3. Observe the level of coolant in the coolant recovery tank. The normal cold engine fluid level must be between "FULL" and "LOW" marks on tank. 4. If the coolant is below the "LOW" mark, add genuine part of 50% concentration coolant to the tank. FG0194 FUL K"ISFE UCELOPL CADON.OD L LLAONW OT" L WEVH WEELN L L BEENTGWINEEEN FG0194 FG0194