5. Clean the outer filter (4, Figure 66) by blowing compressed air from the inside of the filter towards the outside. Do not use more than 205 kPa (30 psi) air pressure. HAOC570L Figure 67 6. Check outer filter by shinning a light through it. If small holes or thinner parts are found on the element after cleaning it, replace the filter. 7. Clean the inside of the air cleaner body and the inside of the air cleaner cover. Do not use compressed air. 8. Properly install the air filter and cover. FG000412 Figure 68 9. Install cover (3, Figure 69) as follows. A. Align cover with the element. B.
Hook the tip of latches (2, Figure 69) to the protruding part of the air cleaner body and lock it in position. 2 C. When locking latches (2, Figure 69) in position, attach them in turn on opposite sides (top, bottom, left, right) in the same way as when tightening bolts. 3 D. Always install cover (3, Figure 69) so evacuator (4) is facing the ground (A). NOTE: Make sure that lips of evacuator are parallel to cover. 4 E. When cover (3, Figure 69) is installed, check that cover (3) is properly seated in air cleaner body. If it is seated, install again. A FG018334 Figure 69 NOTE:
If after cleaning the outer filter, the air cleaner clogged indicator remains "ON", replace the outer and inner filters. Do not clean inner filter. DX225LC-3 Inspection, Maintenance and Adjustment 4-52