Change Pilot Filter NOTE: Change pilot filter after first 250 hours of operation or rebuild, and every 1,000 hours thereafter. AM H H NOTE: If pilot filter clogged warning symbol (Figure 85) on display monitor comes "ON" the pilot filter must be serviced. E F C C rpm Min Max s DIG ISO USB FG018718 Figure 85 WARNING AVOID DEATH OR SERIOUS INJURY The hydraulic oil will be hot after machine operation. Allow the system to cool down before changing pilot filter. 1. Park machine on firm and level ground. Lower the front attachment to the ground and stop engine. 2. Tip breather cap up (1, Figure 83) slightly to release the internal pressure. Figure 86 FG021737 3.
Locate pilot system filter assembly. See Figure 86. 4. Unscrew canister (5, Figure 87) and remove O-ring (3) and filter cartridge (4). NOTE: The canister will be filled with oil. Use caution when removing this assembly. 2 1 3 5. Insert a new filter cartridge and O-ring. Apply a small amount of oil around the entire O-ring and install the canister assembly onto the filter head (1, Figure 87). 4 NOTE: Used filter should always be disposed of according to local laws and regulations. 5 6. After changing pilot filter, vent air from pump and check level of hydraulic oil tank. FG021270 Figure 87 Inspection, Maintenance and Adjustment 4-59 DX225LC-3