Change Air-conditioning Outer Filter The unit is equipped with an air filtration system which filters out dirt and dust particles from air being circulated into operator's cabin. This filter must be cleaned. NOTE: In the unit is being operated in a dusty environment, the cleaning and replacement must be performed more frequently. If filter is damaged, replace damaged filter with a new one. WARNING All service and inspection of air-conditioning system must be performed with the starter switch in the "O" (OFF) position. AVOID DEATH OR SERIOUS INJURY NOTE: All right and left call outs are based on the operator being seated in the operator's seat facing the front. FG018456 Figure 92 1.
Open the cover by using the starter KEY in the left side of the cabin. 2. Remove filter (Figure 93) and replace with new one. 3. Reassemble in reverse order. FG018330 Figure 93 Change Air-conditioning Inner Filter WARNING All service and inspection of air-conditioning system must be performed with the starter switch in the "O" (OFF) position. AVOID DEATH OR SERIOUS INJURY 1. Remove filter by pulling knob outward while pressing the upperpart and lower part of the filter handle which is inside of the left rear part of the cabin. 2. Replace with new one. FG018331 Figure 94 3. Reassemble filter in reverse order. DX225LC-3 Inspection, Maintenance and Adjustment 4-62