Inspection, Maintenance and Adjustment 4-95 DX225LC-3 Electric Viscous Fan Clutch The electrically controlled viscous fan clutch provides optimum cooling fan speeds. This also results in lower fan noise and better fuel efficiency. Coolant, hydraulic oil, and cooled charged air temperatures, together with engine speeds, are monitored for optimum fan speeds. When the electrical wire is broken, the fan speed works at its maximum speed to protect entire cooling system from overheating in any operating condition. The maximum and minimum fan speeds are shown below:
Figure 157 Minimum Speed Maximum Speed Fan Speed (rpm) 600 ±50 1,800 ±50 Removal and Installation of the Cooling Fan Assembly The the following instruction must be followed when handling the cooling fan assembly. 1. The weight of the cooling fan assembly is approximately 9 kg (20 lb), which is heavier than a cooling fan assembly without electric fan clutch. Remove and handle assembly carefully not to damage cooling fan and radiator. 2. If not correctly secured with a tie strap, the electrical Figure 158 harness can be damaged by the cooling fan during operation. Properly secure the electrical harness to fan guard when assembling. 3.
The cooling fan assembly must be assembled with 12 bolts using torque values shown below. A. Before installation, cooling fan subassembly needs to be assembled by using 6 x M8 bolts. (Tightening torque 22 N.m (2.2 kg.m, 16 ft lb)) B. Use 6 x M10 bolts (tightening torque 43 N.m (4.4 kg.m, 32 ft lb)) when installing the cooling fan assembly to the engine. Reference Description Torque Number Cooling Fan 22 N.m 1 (to Clutch) M8 Bolt (2.2 kg.m, 16 ft lb) 2 Figure 159 Clutch (to Engine 43 N.m 2 Pulley) M10 Bolt (4.4 kg.m, 32 ft lb) NOTE: If electrical wire is not properly connected, the cooling fan will run at maximum fan speed. Check fan speed after assembly.
FG021998 FG021999 1 EX1404344 Minimum Speed Maximum Speed Fan Speed (rpm) 600 ±50 1,800 ±50 Reference Number Description Torque 1 Cooling Fan (to Clutch) M8 Bolt 22 N.m (2.2 kg.m, 16 ft lb) 2 Clutch (to Engine Pulley) M10 Bolt 43 N.m (4.4 kg.m, 32 ft lb)