FUEL TRANSFER PUMP (OPTIONAL) IMPORTANT Dry operating fuel pump for more than fifteen seconds can cause wear and/or damage to pump. Cooling and lubrication of pump is achieved by fuel passing through pump. If pump is dry operated, heat generated by moving parts will cause damage to pump rotors, vanes and seals. Do not operate pump for more than fifteen minutes at a time. Continuous usage of pump over recommended time interval will cause overheating of motor and will result in motor damage. Do not use fueling pump for other types of fuel or fluids. (Use only for diesel fuel) Do not use fueling pump for other types of fuel which have a low flash point.
Do not use fueling pump for fuel contaminated with water or high humidity. Moisture in pump mechanism can cause rust and can create pump failure. Always operate pump using strainer installed on inlet hose. This will prevent any foreign materials from being introduced into pump. Always maintain pump and all of its components in a clean condition. If dirt or other foreign materials enter pump, they can become lodged between the rotor and/or vanes and generate heat which can cause pump damage. Do not remove strainer or use a strainer with larger mesh to increase flow of fuel. Be careful not to overfill or spill fuel. Make sure direction of check valve is in line with flow direction of fuel.
Any pump parts or components that become lost, damaged or inoperable must be immediately replaced. DX225LC-3 Inspection, Maintenance and Adjustment 4-96