HANDLING OF ACCUMULATOR WARNING AVOID DEATH OR SERIOUS INJURY Even though the engine is stopped, the hydraulic accumulators for the pilot system are still charged. Do not disconnect any pilot system hoses until accumulator pressure has been released from the circuit. To release pressure, turn the starter switch to "I" (ON) position and operate all hydraulic control levers and forward/reverse travel levers. Even though the engine is stopped, hydraulic actuated components may move while releasing pilot pressure. Keep all personnel and bystanders away from excavator while performing this operation. Move safety lever to "LOCK" position after stopping engine.
DO NOT mishandle accumulator(s), because they contain high-pressure nitrogen gas. DO NOT puncture or apply heat or fire to an accumulator. DO NOT weld on accumulator, or try attaching anything to it. When replacing an accumulator, contact a DOOSAN distributor or sales agency so the gas can be properly released. Wear safety goggles and protective gloves when working on an accumulator. Hydraulic oil under pressure can penetrate the skin and cause death or serious injury. Release pilot accumulator pressure using the following procedure: 1. Park machine on firm and level ground. Lower the front attachment to the ground and stop engine. 2. Move safety lever to "UNLOCK" position. 3.
Turn starter switch to "I" (ON) position. 4. Fully stroke work and travel levers in all directions. 5. Move safety lever to "LOCK" position. 6. Turn key to "O" (OFF) position and remove from starter switch. Figure 162 7. Remove accumulator by unscrewing it slowly. Inspection, Maintenance and Adjustment 4-99 DX225LC-3 FG020085