2. Measuring the distance (A, Figure 164) between the bottom of the side frame and the top of the lowest crawler shoe. Recommended tension for operation over most types of terrain is 290 - 310 mm (11.42 - 12.20 in). NOTE: This measurement can be inaccurate if there is too much mud or dirt or other material in the track assembly. Clean off the tracks before checking clearance. A 3. The increased clearance recommended for muddy, sandy or snowy ground conditions is between 310 - 340 mm (12.20 - 13.39 in). FG000162 Figure 164 WARNING AVOID DEATH OR SERIOUS INJURY The track adjusting mechanism is under very high-pressure. NEVER release pressure too suddenly.
The track tension grease valve should never be backed off more than one (1) complete turn from the fully tightened down position. Bleed off pressure slowly and keep your body away from the valve at all times. If there is problem in the valve thread, the valve might be ejected at high-speed and cause death or serious injury. 4. Track tension adjustments are made through the grease fitting (1, Figure 165) in the middle of each side frame. Adding grease increases the length of an adjustment cylinder (2, Figure 165). The longer the adjustment cylinder, the greater the pressure on the tension spring pushing the track idler wheel outward. 2 5.
If there is not enough slack or clearance in the tracks and the adjustment is too tight, the idler wheel and adjusting cylinder can be retracted by bleeding off grease through hole in valve (3, Figure 165) by loosening valve slowly (3, Figure 165). When grease starts to leak out, stop loosening it. 1 3 FG019868 Figure 165 NOTE: After track tension is adjusted by loosening valve, be sure to tighten valve (3, Figure 165) to 14 kg•m (137 Nm, 101 ft lb). If tightened to a lower torque than standard value, grease may leak. WARNING AVOID DEATH OR SERIOUS INJURY Do not loosen or remove grease fitting (1, Figure 165) until pressure is entirely bled off by loosening valve (3, Figure 165) slowly.
Inspection, Maintenance and Adjustment 4-101 DX225LC-3