Toyota — Torque Converter

3 - 33 Seal rlng 011 seal Point Operations [Point 1 I Disassembly: Be careful as oil exists in the torque convert - er ASSY. The torque converter ASSY cannot be disas - sembled. Reassembly: Coat grease on the seal ring and oil seal lip be - fore installation. Reassembly: Rotate the torque converter ASSY to make the extension pawl fit into the oil pump drive gear groove. [Point 21 Disassembly: SST 09950 - 2001 7 [Point 31 Disassembly: Use the service bolt for removal Service bolt size: MI 0 x 1.25 [Point 41 Disassembly: Extract the idle shaft by inserting a screw - driver or the like in the lock plate groove. Reassembly: Adjust the thrust clearance of idle gear No.2. 1.

Push the idle gear to one side and measure the clear - ance between the bearing and spacer. Standard clearance: 0.04 - 0.6 mm (0.0016 - 0.024 in) 2. If the measured value does not satisfy the standard, replace the spacer switch new ones. Install spaces on both sides of the idle gear.