[Point 51 Disassembly: SST 09308 - 0001 0 SST [Point 61 Disassembly: Use a copper rod and tap the end of the shaft from the rear side to drive the shaft out to the front side. Hold the clutch drum during this operation. Disassembly: After removing the clutch shaft 1 remaining in the case. Wlclutch drum, remove output gear No. Reassembly: Coat grease on the seal ring and install it at the end of the clutch shaft. Reassembly: Adjust the thrust clearance of clutch shaft No.2 (forward). 1. After installing clutch shaft No.2 Wlclutch drum No.2 in the case, install shims on the shaft and temporarily install the front cover.
Set a dial gage on the side of the clutch gear, and meas - ure the thrust clearance by moving the clutch drum back and forth. Standard clearance: 0.05 - 0.55 mm (0.0020 - 0.021 7 in) If the measured value does not satisfy the standard, select the shims to be used at the tip end of the shaft. Shim thickness: (0.020,0.035 and 0.0492 in) 0.5,O.g and 1.25 mm