[Point 71 Disassembly: After removing the lock washer and set bolt, rotate the idle shaft counterclockwise for removal. Reassembly: Clean the idle shaft threaded portion, and check if it can be screwed in lightly without the idle gear. Reassembly: Install the bearing inner race on the idle gear and tape the bearing so as not to let it fall. After inserting the idle gear into the case, re - move the tape and insert the idle shaft. Tighten the idle shaft to the specified torque. T=4.90 - 9.81 N-m (50 - 100 kg-cm) [3.62 - 7.24 ft-lbl [Point 81 Disassembly: SST 09308 - 0001 0 Reassembly: SST 09620 - 3001 0 SST [Point 91 Disassembly: Extract clutch shaft No. Wlclutch drum No.
1 1 to the converter side. Reassembly: Coat grease on the seal ring and install it at the end of the clutch shaft.