Reassembly: Adjust the thrust clearance of clutch shaft No. 1 (reverse). 1. Install the shim on the stator shaft and temporarily in - stall the oil pump Wlstator shaft. .-- -- - -, 2. Set a dial gage on the front end of the clutch shaft, and measure the thrust clearance by moving the clutch drum back and front. Standard clearance: 0.1 5 - 0.75 mm (0.0059 - 0.0296 in) 3. If the measured value is not within the standard range, select and change the shim thickness at the stator shaft. Shim thickness: 0.71, 0.9, 1.12 and 1.4 mm (0.0280, 0.035, 0.0441 and 0.055 in) [Ponit 101 Disassembly: After removing the output cover set bolts, use the SST for removal. SST 0981 0 - 201 72 - 71 Reassembly:
Adjust the thrust clearances related to the out - put shaft. 1. Place a spacer and shim(s) on the output gear No. 2, and temporarily install the output cover Wloutput shaft. 2. Tap the output shaft with a hammer to eliminate the thrust clearance of the gear, spacer and shim. 3. Set a dial gage on the upper face of the output shaft, and pry upward with a screwdriver to measure the move - ment (thrust clearance). Standard clearance: 0.03 - 0.51 mm (0.0012 - 0.0201 in) 4. If the measured value does not satisfy the standard, select the shims to be used. Shim thickness: 0.9, 1.25 and 1.6 mm (0.035, 0.0492 and 0.063 in)