Disassembly~reassembly: Measure the thrust clearance of each gear. Countergear Standard thrust clearance: 0.1 - 0.2 m m (0.004 - 0.008 in) Limit thrust clearance: 0.3 m m (0.01 2 in) Transmission idle gear Standard thrust clearance: 0.1 - 0.25 rnm (0.004 - 0.0098 in) Limit thrust clearance: 0.4 m m (0.016 in) Reverse idle gear Standard thrust clearance: 0.1 - 0.4 mm (0.004 - 0.016 in) Limit thrust clearance: 0.7 mm (0.028 in) [Point 71 Inspection: Measure the bushing outside diameter. Standard bushing outside diameter: 44.0 mm (1.732 in) Limit bushing outside diameter: 43.9 mm (1.728 in) . Reassembly: Coat grease (molybdenum disulfide grease) on the bushing. Inspection:
Check the clearance between the hub sleeve and fork. (See Point 3.) Inspection: Coat gear oil on the gear taper portion and bring the ring manually into contact to check no slipping. Inspection: Insert the clearance between the synchronizer ring and gear. Forward1 reverse Standard clearance: 1 .I0 - 2.30 mm (0.0433 - 0.0906 in) 1st & 2nd Standard clearance: 1 Limit clearance: 0.3 m m (0.012 in) .I0 - 1.90 mm (0.0433 - 0.0748 in) Limit clearance: 0.3 m m (0.01 2 in) Reassembly: When driving the bearing into the counter- shaft, make the chamfered side (inside di - ameter) of the bearing (spacer) face outward.