Reassembly: Make the following adjustments after install - ing the adjusting nut. 1. Adjust the side bearing starting force. (1) Set a dial gage on the rear face of the ring gear. (2) Tighten the adjusting nuts on both sides until the thrust clearance is eliminated. 1.2 ton series: SST 09630 - 101 10 - 71 3 ton series: SST 09330 - 1 0 1 70 - 7 1 (3) Tighten the adjusting nuts on both sides one more notch each from the position where the thrust clear - ance becomes 0. 2. Adjust the backlash between the drive pinion and ring gear. (1) Set a dial gage into vertical contact with the ring gear tip surface.
(2) For adjustment, move the differential case by loos - ening one adjusting nut by one notch while tighten - ing the other by one notch until the backlash satis - fies the following standard: Backlash: 1.2 ton series: 0 . 2 - 0 . 3 mm (0.008 - 0 . 0 1 2 in) 3 ton series: 0 . 3 - 0 . 4 mm (0.012 - 0.016 in) (3) After backlash adjustment, tighten the side bearing adjusting nut on the ring gear side by 1.5 t o 2 notches. 3. Check teeth contact between the drive pinion and ring gear. (1) Coat red lead thinly and uniformly on 7 to 8 teeth of the ring gear.
Set a box wrench on the lock nut of the output gear and turn the ring gear several turns in the forward and in the reverse traveling directions. Check according to the teeth contact trace. If the teeth contact is incorrect, carry out drive pin - ion protrusion adjustment and ring gear backlash ad - justment. (2) Correct teeth contact The teeth contact should be slightly on the small end side of the center of the tooth width as illus - trated. Correct teeth contact