Reassembly: Install the thrust washer of the side gear with its oil groove side facing the tooth flank. Reassembly: Coat chassis grease (molybdenum disulfide grease) uniformly on both sides of the spider pinion thrust washer before reassembly. [Point 71 Disassembly: Use the service bolt for removal. Service bolt size: M 1 0 x 1 .25 [Point 81 Inspection: Measure the backlash between the output gear and reduction gear. Backlash: 0.1 - 0.2 mm (0.004 - 0.008 in) Reassembly: Adjust the drive pinion protrusion by means of the drive pinion bearing retainer shims. Select the shim by teeth contact inspection. (See Point 3.) Shim thickness:
0.10-0.1 5.0.35 and 0.45 mm (0.0039~0.0059~0.0138 and 0.01 77 in) [Point 91 Reassembly: After the end of teeth contact inspection and drive pinion protrusion adjustment, caulk the output gear lock nut. Point contact