/I Point Operations I [Point ,ssT / 11 Disassembly.reassembly: Check the match marks on the sector shaft and pitman arm. Disassembly: SST 09950 - 200 1 7 Reassembly: After installing the pitman arm, adjust the backlash of the sector gear. 1. Stop the pitman arm in the lock - to - lock center position and set a dial gage on the end of the pitman arm. 2. Tighten the adjusting bolt until the backlash at the cen - ter of the pitman arm becomes 0 mm (0 in). 3. After rotating the shaft of the ball screw set by 3 to 4 turns, place the pitman arm in the lock - to - lock center position and install the SST on the shaft to measure the overall starting force. SST 09470-10171-71 Overall starting force:
2.0 - 5.9 N (0.2 - 0.6 kg) 10.44 - 1.3 Ibl 4. If the overall starting force does not satisfy the stan - dard, place the pitman arm again in the lock - to - lock center position and make adjustment by tightening or loosening the adjusting bolt. 5. Measure the backlash where the pitman arm is in the lock - to - lock center position and where the pitman arm is turned fully clockwise/counterclockwise. Backlash: Lock - to - lock center position: (0 in) End of 0 mm clockwise/counterclockwise rotation: 0.1 - 1.5 mm (0.004 - 0.059 in) 6. After backlash adjustment, tighten the adjusting bolt lock nut and cap nut.