[Point 21 Disassembly: After removing the side cover Wlsector shaft, tighten the adjusting bolt until freeing from the side cover for disconnecting the sector shaft. Inspection: Measure the clearance between the sector shaft and adjusting nut. If it exceeds the limit, select and use the appropriate adjusting plater to obtain the standard clearance. Limit clearance: 0.1 mm (0.004 in) Adjusting plate thickness 1 ton series: 1.95-2.00-2.05-2.10 and 2.15 mm (0.0768~0.0787~0.0807~0.0827 and 0.0846 in) 2.1.2.2.2.3.2.4 and 2.5 mm 2.3 ton series: (0.083~0.087~0.091~0.094 and 0.098 in) I Reassembly: Fill grease in the slit groove of the sector shaft where the adjusting bolt fits. Reassembly:
Assemble by bringing the top of the tooth crest of the sector shaft into contact with the center of the root of the ball screw set. [Point 31 Reassembly: Adjust the ball screw set starting force. I / 1 ton series: Temporarily tighten the lock nut to a torque of 9.81 - 19.61 N.m (100 - 200 kg - cm) L7.24 - 14.47 ft - lbl, rotate the ball screw set shaft for adaptation and loosen the lock nut. Then install the SST and measure the starting force. SST 09470 - 1 01 71 - 71 Starting force: 0.98 - 2.9 N (0.1 - 0.3 kg) l0.22 - 0.66 Ib] Adjust the degree of lock nut tightening to make the starting force satisfy the standard. 2.3 ton series:
After tightening the lock nut to a torque of 9.81 - 29.42 N.m (100 - 300 kg - cm) [7.24 - 21.71 ft - lb], return the lock nut by 1 80°, then tighten the lock nut again to a torque of 0.0294 [2.17 ft - lb]. N.m (30 kg - cm) Reassembly: After adjusting the starting force, be sure to caulk the lock nut.