Reassembly Procedure The reassembly procedure is the reverse of the disassembly procedure. In the reassembly procedure, however, reverse the order of steps 2 and 3 in disassembly procedure. (Install the pawl lever stopper after installing the hold spring.) Note: Refer to the note for the front axle shaft,hub installation procedure (on page 7 - 10). Check no grease or oil adhesion on the brake lining and brake drum interior surface before reassembly. Set the installed brake shoe outside diameter to the following dimension by tightening the adjusting screw before installing the hub Wlbrake drum. (Set it to approx.
1 mm (0.04 in) smaller than the brake drum inside diameter.) Installed brake shoe outside diameter: 309 mm (12.17 in) Coat thread tightener (08833 - 00070) on the brake drum set nut before tightening. (Applicable when the hub and brake drum are disconnected.) Drain air from the brake system after reassembly. After reassembly, adjust the brake performance. For adjustment repeat vehicle forward travel and reverse travel and stop the vehicle by depressing the brake pedal each time. The tightening torque for each portion is as follows: Unit: N.m (kg-cm)[ft-lbl Point Operations [Point 1 I Disassembly~reassembly: SST 0951 0 - 31 960 - 7 1 Inspection:
Measure the free length of the hold down spring. Standard free length: 31.3 mrn (1.232 in) Limit free length: 28.2 m m (1.1 10 in) Brake drum set nut (hub bolt set nut) - - [I - 2 ton series: 147.10 186.33 (15 00 1900) 08.53 137.471 - - 3 ton series: 166.71 205.94 (1700 2100) [123.00-151.941 Backing plate self lock nut - - 117.68 137.29 (1200 1400) 186.82- 101.291 Wheel cylinder set bolt - - 14.71 19.61 (150 200) [10.85- 14.471