[Point 101 Inspection: Measure the brake drum inside diameter. (1 2.20 in) Limit inside diameter: 312 mm (12.28 in) Standard inside diameter: 31 0 mm AIR BLEEDING FROM BRAKE SYSTEM Note: Carry out air bleeding operation while adding brake fluid to the reservoir tank to prevent it from becoming insufficient. 1. Bleed air from the brake master cylinder. ) Depress the brake pedal several times to compress the air in the piping and maintain that state. (2) Loosen the breather plug to bleed air in the piping with the brake fluid and tighten the plug immediately be - fore the brake fluid discharge stops. (3) Repeat steps (1 (2) above until no air bubble is seen in the flowing out brake fluid.
(1 and 2. Bleed air from wheel cylinders RH and LH. (1) Perform the same operation as above for each of the wheel cylinder RH and LH at a time. 3. Add brake fluid to the specified level. (1 ) For addition, pour brake fluid through the filter provid - ed at the reservoir tank. (2) Add brake fluid to the shouldered portion in the reser - voir tank.