Toyota — Mast

Mast Roller Removal~lnstallation 1. Remove the lift bracket. (See the mast ASSY removal procedure steps 1 to 4 on page 13-5.) 2. Jack up the vehicle and support the tires with wooden blocks. Lock the front and rear tires to prevent rota - tion. 3. Tilt the lift cylinder. (1) Remove the hose cover at the bottom of the mast and disconnect the lift cylinder hose on the LH side. (2) Remove the lift cylinder bottom set bolts. (3) Sling the inner mast upper tie beam with a wire and slightly hoist it. (4) Remove the lift cylinder rod end set bolts, and dis - connect the rod end by hoisting the inner mast. (5) Remove the lift cylinder support.

(6) Tile the lift cylinders LH and RH and tie them with ropes to the outer mast tie beam. 4. Remove the mast rollers. (1 1 Lower the hoisted inner mast slowly until mast roll - ers are visible, and support the bottom with wooden blocks. (2) Remove the inner mast rollers and shims. (3) Remove the outer mast rollers and shims. 1 5. The installation procedure is the reverse of the removal procedure. Shlm