(4) Distribute the shim thickness equally to the left and right sides. (For the shim replacement procedure, see the lift bracket disassembly section on page 13 - 1 0.) (5) Install the side rollers. (6) Side roller adjustment shall be made after adjusting the middle and lower lift rollers. Bring the side roller on one side into contact with the mast side surface, and make adjustment by shim in - sertion to make the clearance between the side roller and inner mast side surface on the opposite side satisfy the following standard. (0 - 0.024 in) Shim thickness:
0.5 and Standard clearace D = 0 - 0.6 mm .O mm (0.020 and 0.039 in) (7) The shim thickness shall be distributed equally into the left and right sides. (Shim replacement is possi - ble on the vehicle. For the side roller installation, see the lift bracket disassembly section on page 13 - 1 0.) 1 2. After the adjustment, the lift bracket should move smoothly along the overall mast length. Shim