Mitsubishi — 1.1.2 Inspecting valve clearance

ADJUSTMENT AND OPERATION 1.1.2 Inspecting valve clearance (1) Set No. 1 cylinder to the top dead center in compression stroke. This position is where the TDC mark on the crankshaft pulley aligns with the mark on the gear case. Note: The compression top is where the rocker arm does not move when the crankshaft is rotated in the forward and backward direction by both 20°approx. If the rocker arm moves, it is the top dead center in exhaust stroke. Rotate the crankshaft another full turn to set the No. 1 cylinder to the top dead center in compression stroke. (2) Start adjusting the valve clearance from the No.

1 cylinder and adjust the valve clearance of other cylinders according to the ignition order. Note: To set the next cylinder to the compression top after adjustment of No. 1 cylinder, rotate the crankshaft in the forward direction (clockwise toward the timing gear case) by the angle corresponding to the number of cylinders. (3) Insert a thickness gauge between the rocker arm and Mark on gear case side Timing mark bridge cap.Turn the adjusting screw while measuring the clearance, and adjust the clearance so that the thickness gauge can move with slight stiffness. (4) After adjustment, tighten the lock nut firmly. Then, check the clearance again.

Adjusting valve clearance 13-3 Model . . Ignition order Rotation angle  q  q TDC mark on crankshaft pulley side Item Standard Valve clearance Inlet 0.25 mm [0.0098 in.] Exhaust 0.25 mm [0.0098 in.]