ADJUSTMENT AND OPERATION 1.2 Inspecting fuel injection timing &$87,21 To prevent the outflow of fuel, stop the fuel supply before removing the delivery valve. Valve The fuel injection timing varies with the output, speed and other engine specifications. Be sure to check the engine's specification sheet. (1) Remove the No. 1 fuel injection pipe. (2) Remove the No.1 delivery valve holder of the fuel injection pump. (3) Pull out the spring and delivery valve. Then do not remove the delivery valve seat. (4) Install the delivery valve holder. (5) Remove the tie rod cover. (6) Disconnect the tie rod from the control rack. (7) Set the control rack to the medium position of the operating range.
(8) Feed fuel from the fuel hose and check that the fuel flows out from the delivery holder. (9) Rotate the crankshaft forward (clockwise). The fuel injection timing is the moment when the fuel stops flowing from the delivery valve holder outlet. Note: When the fuel stops flowing, rotate the crankshaft backward (counterclockwise) to allow the fuel flowing again. And then, rotate the crankshaft forward (clockwise) to ensure the accurate timing when the fuel stops flowing. (10) It is normal that IT mark of the crankshaft pulley aligns the mark on the gear case at the position that fuel flow stopped.
Valve seat Delivery valve Removing delivery valve Tie rod clip Tie rod Control rack Connecting and disconnecting tie rod Fuel injection timing mark on gear case side Fuel injection timing 2 q 2 q Injection timing mark on pulley side TDC mark Fuel injection timing 13-4