ADJUSTMENT AND OPERATION 1.3 Adjusting fuel injection timing &$87,21 When using the shim, apply sealant to both side of the shim to prevent oil leakage. (1) If the fuel injection timing does not meet the specified value, increase or decrease the thickness of the fuel injection pump adjusting shim to adjust the timing. (adjusting value: standard value ± 1.5) Note: A change in thickness of the shim by 0.1 mm [0.004 in.] results in a change in the fuel injection timing by approx 1°. (2) After adjusting, check that the fuel injection timing is properly adjusted. (3) Close the cock of the fuel filter, and reassemble the delivery valve, spring, fuel injection pipe.
(4) With the delivery valve installed, check the fuel injection timing as follows: Note: If the fuel injection pump and the engine are dirty, removing the delivery valve allows dirt and dust to enter the fuel injection pump. (5) Remove the tie rod cover and disconnect the tie rod from the control rack. (6) Set the control rack to the medium position in the operating range and then remove the No. 1 fuel injection pipe on the nozzle side. When the crankshaft is gradually rotated forward (clockwise), fuel begins to swell at the tip of the pipe. This timing is the fuel injection timing. In this case, the timing is delayed by 1° as compared to the normal fuel injection timing.
Adjusting shim Mark on timing gear case IT mark (One division corresponds to 2°) Advanced by this angle Retarded by this angle TDC mark Crankshaft pulley Add shims (thicker) Reduce shims (thinner) Advance Retard Adjusting fuel injection timing 13-5