Mitsubishi — 1.4.3 Adjusting high idle speed

ADJUSTMENT AND OPERATION 1.4 Inspecting and adjusting low idle speed and high idle speed &$87,21 (a) The minimum no-load speed (low idle speed) and the maximum no-load speed (high idle speed) of each engine have been checked on test bench and then their setting bolts have been sealed by sealing cap at the factory. Only the service shops designated by Mitsubishi are authorized to perform checking and adjustment of these settings. (b) Be sure to seal all the external stoppers in the same manner as they were sealed at the factory if adjustments have been made on the governor. Whether the seals are intact or not has important bearing on the validity of claims under warranty.

Be sure to seal all of the specified locations. (c) When inspecting and adjusting the governor, be prepared to operate the engine stop lever manually in anticipa- tion of engine overrevving (running at an extremely high speed). 1.4.1 Preparation (1) Operate the engine to warm up until coolant temperature reaches 60°C or higher. (2) Make sure that valve clearance, fuel injection timing, nozzle opening pressure, spray condition, and oil sealing are normal. Low idle set bolt 1.4.2 Adjusting low idle speed (1) Loosen the lock nut of idling set bolt. (2) By turning the bolt, adjust the low idling speed. (3) Secure the set bolt with the lock nut.

High-speed set bolt 1.4.3 Adjusting high idle speed (1) Loosen the lock nut of high speed set bolt. (2) By turning the bolt, adjust the high idling speed. (3) Secure the set bolt with the lock nut. Adjusting engine speed 13-6