SERVICE DATA 1.4 Lubrication system Table 2-4 Maintenance service data table - Lubrication system Unit: mm [in.] 1.5 Cooling system Table 2-5 Maintenance service data table - Cooling system Unit: mm [in.] 1.6 Inlet/Exhaust system Table 2-6 Maintenance service data table - Inlet/Exhaust system Unit:
mm [in.] 2-6 Inspection point Nominal Standard Limit Remark Clearance between oil pump housing inside diameter and oil pump outer gear outside diameter ø 75.5 [2.972] 0.100 to 0.196 [0.0039 to 0.0077] 0.3 [0.012] Clearance between oil pump outer gear width and oil pump housing 10 [0.04] 0.040 to 0.100 [0.0016 to 0.0039] 0.25 [0.0099] 0.29 ± 0.029 MPa {3.0 ± 0.3 kgf/cm²} [43 ± 4.3 psi] 0.05 ± 0.01 MPa {0.5 ± 0.1 kgf/cm²} [7 ± 0.7 psi] Inspection point Nominal Standard Limit Remark Thermostat Temperature at which valve starts opening 76.5 ± 1.5°C [167 to 172°F] Replace Temperature at which valve lift becomes 6 [0.24] or more 90°C [194°F] Thermoswitch 111 ± 3.5°C [225 to 238°F] 30 mΩ (in oil of 120°C [248°F]) Deflection amount of belt (when it is pushed between crankshaft pulley and alternator pulley with a force of approx.
98 N {10 kgf} [22 lbf]) Approx. 10 [0.39] Inspection point Nominal Standard Limit Remark Distortion on mounting surfaces of intake cover and exhaust manifold 0.15 [0.0059] Repair by grinding or replace