Komatsu — REMOTE POSITIONER

. OPERATION OPERATION possible to detect the 3 - 112 METHOD OF SETTING REMOTE PO SITIONER STOP POSITION 1. 2. 1. When remote positioner RAISE stop display lamp (1) is lighted up, operate the lift arm control l ever to raise the lift arm to the desired height (a position abov e horizontal). Then return the lift arm control l ever to the HOLD position and press remote positioner RAISE position set switch (2). Remote positioner RAISE stop d isplay lamp (1) will go out, and remote positioner RAISE set p seconds.

ilot lamp (3) will flash for 2.5 When remote positioner RAISE set pilot lamp (3) goes out and remote positioner RAISE stop d isplay lamp (1) also goes out, the RAISE stop position is sav operation is completed. When remote positioner LOW ed to memory and the setting ER stop display lamp (4) is 2. is lighted up, operate the lift arm c ontrol lever to lower the lift arm to the desired height (a position below horizontal). Then return the lift arm control l ever to the HOLD position and press remote positioner LOWE R position set switch (5). p display lamp (4) will go out, Remote positioner LOWER sto and remote positioner LOWER 2.5 seconds.

When remote positioner LOWE set pilot lamp (6) will flash for R set pilot lamp (6) goes out and remote positioner LOWER stop display lamp (4) also goes out, the LOWER stop position is saved to memory and the setting operation is completed. SENSOR ADJUSTMENT FUNCTION This function offsets the error caus correct position data for the work e Always carry out this function when replacing the controller potentiometer or work equipmen