. OPERATION OPERATION REMARK ADJUSTING REMOTE POSITIONER 3 - 113 SENSOR ADJUSTMENT MET 1. Set the work equipm ent to the lift arm top end position 2. Keep re mote positio ner LOWER position se t switch and remote p ositioner RA ISE position set switch ( 2) presse d at the same tim e for at leas t 3 seconds. When re mote position er LOWER set pilot lam p (3) and remote positione r RAISE se t pilot lamp (4) light the switches and set to th e sensor ad justment m 3. The rem ote positione r LOWER s et pilot lamp (3) and remote positione r RAISE set pilot lamp (4 ) light up for 2 seconds, and when bo th lamps go out, the offse t is recorde d in memory 4.
If the la mps flash in Step 3, the potentiome ter outpu t is not within th e offset rang e, so adjust t he potentio meter mount Adjustm ent can be ca rried out at t he posture in Step 1 After adjustm ent each pot entiometer,always carry out Step s 1 and 2 a gain, and check that t he condition in Step 3 is the set lamps light u p for 2 seco nds and then When the lift arm has bee n removed o r the setting does not work efficiently, please contact y our Komats u distributor for adjustme