. MAINTENANCE SERVICE PROCEDURE CHANGE BRAKE OIL WARNING cause burns. Wait for the remove cover (2) under the brake 4 - 78 The parts and oil are at hig h temperature immediately after the engine is stopped, and ma e starting the work. ap, turn it slowly to release the internal pressure, then remove it. temperature to go down befor When removing the oil filler c ap, turn it slowly to release the i nternal Refill capacity: 31 liters (8. Prepare a container to cat 1. Loosen bolt (1), then r component box. 2. Insert the supplied hose i nto the oil drain port of drain valve (3) and set a container in po 3.
Open cover (4) on top of t he platform on the left side of the cab, then remove the cap from oil filler (F). of oil filler (F), then turn the cap ve it. owly and drain the oil. ten drain valve (3), and remove the Pull knob (5) of the cap counterclockwise to remo 4. Loosen drain valve (3) sl 5. After draining the oil, tigh hose. 6. Use bolt (1) to install cove r (2) under the brake component box. 7. Replace the brake oil filt (PAGE 4-79)". er element. For details, see "REPLACE FILTER ELEMENT IN BRAKE OIL TANK ort (F) to the specified level, then install the oil filler cap. o the top mark of the specified level. For details, see "CHECK BRAKE OIL TANK 3-80)".
d the air from the hydraulic circuit. For details, see "BLEEDING AIR FROM BRAKE PAGE 4-36)". en close cover (4). TANK 8. Add oil through oil filler p ort (F) to the specified level, then install 9. Check that the oil is up t level. For LEVEL, ADD OIL (PAGE 10. Start the engine and blee d the air from the hydraulic circuit. For details, see "BLEE HYDRAULIC CIRCUIT ( 11. Install the oil filler cap, th