Isuzu — 7-18 Periodic maintenance

If the vehicle is equipped with ABS, remove the ABS fuse (60A) from the fuse box before beginning the air bleeding procedure. If the bleeding is performed without removing the ABS fuse, the air cannot be bled completely and the ABS EHCU may be damaged. After bleeding, be sure to install the fuse in place. 2. Start and keep the engine running until the vacuum accumulates sufficiently. To bleed, proceed as follows: 1. Set the parking brake firmly. CAUTION Bleeding of the brake hydraulic circuit If air enters the brake lines, it will cause poor braking.

Therefore, the bleeding operation should be performed if the brakes have been used with an excessive level of brake fluid in the reservoir or if the brake pipes have been disconnected in the course of brake servicing. Bleeding operation calls for the cooperative action of two men. - 7–36 - SERVICE AND MAINTENANCE Brake lining clearance can also be automatically adjusted by depressing the brake pedal as far as possible with the vehicle in motion. Do this several times to ensure accurate adjustment. NOTE