SERVICE AND MAINTENANCE 5. Remove the rubber cap from the bleeder screw and wipe and clean the bleeder screw. Connect a vinyl tube to the bleeder screw and insert the other end of the vinyl tube into a transparent container. 4. Bleeding of the brake hydraulic circuit should be performed in the following sequence: Left-hand rear wheel (model with ABS only) –> Right-hand rear wheel –> LSPV or DSPV (if equipped) –> Right- hand front wheel –> Left-hand front wheel. LHD Left-hand rear wheel (model with ABS only) –> Right-hand rear wheel –> LSPV or DSPV (if equipped) –> Left- hand front wheel –> Right-hand front wheel.
RHD - 7–37 - (Vehicles with the hydro booster) Bleed air first from the hydro booster working fluid. Then, with the engine running, bleed air from the brake hydraulic circuit. Air cannot be bled completely if the engine is turned off. 3. Check the level of brake fluid in the reservoir and replenish it as necessary. Brake booster (master-vac) will be adversely affected if the bleeding operation is performed without running the engine. CAUTION