UEN00665-00 50 Disassembly and assembly a Stick dam rubber (6c) of the lower side of the front window glass along the outside edge of the lower line, dif- ferently from other dam rubbers (6). (If it is stuck along the inside, it will be seen through the transparent part of the glass.) 3) Stick dam rubber (6) for door lower win- dow glass (3) to the position as shown in the figure. a Stick dam rubber (6b) additionally to door lower window glass (3). q Positions to stick additional dam rubber to the door lower window class: (j) : 110 mm (k) : 90 mm (m) : 200 mm 5. Position the new window glass.
1) Check the clearance between the window glass and the operator's cab on the right, left, upper, and lower sides, and then posi- tion the window glass to be the clearances evenly. 2) Stick tapes [6] between window glass (9) and operator's cab (8) and draw position- ing line (n). a Stick tapes [6] for positioning to 3 points, that is, right, left and lower parts of the right side window glass, left side rear window glass, and door lower window glass for accurate posi- tioning. 3) Cut the tape between window glass (9) and operator's cab (8) with a knife, etc. and then remove the window glass.
a Do not remove the tapes left on the window glass and the operator's cab before installing the window glass. 4) Stick dam rubber (6) for front window glass (4) to the position as shown in the figure. 10 PC210, 230, 240-8