UEN00100-00 10 Structure, function and maintenance standard Main relief valve 1 1. Spring 2. Poppet Function q Set pressure of the relief valve is in two stages. q When power is needed, pilot pressure (P) is turned ON and the set pressure becomes higher. q The set pressure of relief valve is determined by spring (1) installed load. (1st stage) Operation q Respective setting is not required for both the 1st and 2nd stages. Setting the 1st stage com- pletes the setting of the 2nd stage. 1. If pilot pressure (P) is OFF: Low-pres- sure setting Set pressure is determined by spring (1) installed load. 2. If pilot pressure (P) is ON:
High-pres- sure setting Spring (1) installed load is added with pilot pressure (P) applied to the area of poppet diameter (d1), raising the set pressure to higher level. 54 PC210, 230, 240-8