20 Standard value table UEN00227-00 PC210, 230, 240-8 7 Applicable model PC210, 210LC, 210NLC, 230NHD-8 Cate- gory Item Measurement condition Unit Standard value for new machine Judgement criteria Travel Travel speed (actual run) • Hydraulic oil temperature: Within operating range • Engine running at high idle • Working mode: P mode • Flat ground • Time required for traveling 20 m after 10 m trial run • For measuring posture, see Travel 2 Lo sec. [PC210/LC/NLC] 24 ± 2.5 [PC210/LC/NLC] 21.5 – 27.5 [PC230NHD] 28 ±2.5 [PC230NHD] 25.5 – 31.5 Mi sec. [PC210/LC/NLC] 17 ± 2.5 [PC210/LC/NLC] 14.5 – 20.5 [PC230NHD] 20 ±2.5 [PC230NHD] 17.5 – 23.5 Hi sec.
[PC210/LC/NLC] 13 ±1.0 [PC210/LC/NLC] 12.0 – 15.0 [PC230NHD] 13 ±1.0 [PC230NHD] 12.0 – 15.0 Travel deviation • Hydraulic oil temperature: Within operating range • Engine at high idle • Working mode: P mode • Travel speed: Lo • Solid and flat ground • Swerving amount while traveling 20 m (X) after initial 10 m trial run • For measuring posture, see Travel 2 and 3 mm Max. 150 Max. 250 Hydraulic drift of travel • Hydraulic oil temperature: Within operating range • Engine stopped • Parking machine on slope of 12° with sprocket facing upslope • Sliding distance for 5 minutes • For measuring posture, see Travel 4 mm 0 0 Leakage of travel motor • Hydraulic oil temperature:
Within operating range • Engine at high idle • Traveling with sprocket locked • Oil leakage amount for one minute with traveling in relief condition l/min 13.6 27.2 Work equipment Hydraulic drift of work equipment Whole work equipment • Hydraulic oil temperature: Within operating range • Flat and level ground • Fill bucket with dirt or rated load (0.8m3: 1,440kg) • Boom horizontal, arm fully retracted, bucket cylinder fully extended • Engine stopped • Work equipment control lever in NEUTRAL position • Fall amount for 15 minutes as measured every 5 minutes starting immediately after initial setting • Whole work equipment: Lowering distance of tooth tip • Boom cylinder:
Retraction distance of cylinder • Arm cylinder: Extraction distance of cylinder • Bucket cylinder: Retraction distance of cylinder • For measuring posture, see Work equipment 1 mm Max. 600 Max. 900 Boom cylinder mm Max. 18 Max. 27 Arm cylinder mm Max. 160 Max. 240 Bucket cylinder mm Max. 40 Max. 58