30 Testing and adjusting UEN00228-00 Measuring compression pressure 1 a Measuring tools for compression pressure k Stop the machine on a level ground and lower the work equipment to the ground. a Measure the compression pressure under the following condition. 5. Install adapter C3 to the injector mounting part with the injector clamp and connect compres- sion gauge C1 . a Install the gasket to the adapter end with- out fail. q Engine oil temperature: 40 – 60°C 1. Open the engine hood and remove cylinder head cover (1).
a Since the breather connector on the rear side of the cylinder head cover is con- nected to the flywheel housing through the O-ring, pull it together with the cylinder head cover. 3 Injector clamp mounting bolt: 1st time : 3.5 ± 0.35 Nm {0.36 ± 0.04 kgm} 2nd time: 75 ± 5 ° (Angle tightening) a If a little quantity of engine oil is applied the joint of the adapter and gauge, air does not leak easily. 6. Install rocker arm assembly (2) on the exhaust side and adjust the valve clearance. a See “Adjusting valve clearance”. 2. Remove the mounting bolts of rocker arm assembly (2) on the exhaust side, and then remove rocker arm assembly (2).
a When removing the injector, you do not need to remove the rocker arm assembly on the intake side. 3. Remove fuel tube (3), and then remove inlet connector (7) in the cylinder head. a The inlet connector is connecting the fuel tube to the injector. 4. Disconnect injector wiring harness. Using tool C2 , remove injector (4). PC210, 230, 240-8 11 Symbol Part No. Part name C 1 795-502-1590 Compression gauge 2 795-799-6700 Puller 3 795-790-4410 Adapter 6754-11-3130 Gasket