Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring and adjusting oil pressure in work equipment, swing, and travel circuits

UEN00228-00 30 Testing and adjusting a The actuators in the table are arranged in the order when the control valve is seen from the front of the machine (and an attachment is installed to the service valve). 3. Measuring unload pressure 1) Start the engine, set the working mode in the power mode (P), and turn the auto- decelerator OFF. 2) Run the engine at high idle, set all the levers and pedals for work equipment con- trol, swing control, and travel in neutral, and measure the oil pressure. a The pressure measured when the unload valve is unloaded is indicated. 4. Measuring work equipment relief pressure 1) Start the engine and move the cylinder to be measured to the stroke end.

2) Set the working mode in the power mode (P). 3) Run the engine at high idle, operate the right and left work equipment control levers to relieve the cylinder, and measure the oil pressure. a The pressure measured when the main relief valve is relieved is indi- cated (If the boom is lowered singly, 28 PC210, 230, 240-8 Actuator Valve relieved Rear pump (R unload valve) (R main relief valve) Service Safety-suction valve Bucket R main relief valve Left travel R main relief valve Boom Raise: R main relief valve Lower:

Safety-suction valve (Pump merge-divider valve) (Travel junction valve) Front pump (Self pressure reducing valve) Swing Swing motor safety valve Right travel F main relief valve Arm F main relief valve (F unload valve) (F main relief valve) (Centralized safety valve) (Back pressure valve)