Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring and adjusting oil pressure in work equipment, swing, and travel circuits

30 Testing and adjusting UEN00228-00 the safety-suction valve of the control valve for lowering the boom is relieved). a If the power maximizing switch is released, the main relief valve is relieved at low pressure. If the former is pressed, the latter is relieved at high pressure. a If the swing lock switch is set in turned ON, the 2-stage relief solenoid valve is kept turned ON and the relief valve is relieved at high pressure. Accordingly, keep the swing lock switch turned OFF. a The pressure measured when the main relief valve of the control valve is relieved is indicated. The travel circuit is always relieved at high pressure. 8.

Work after finishing measurement After finishing measurement, remove the mea- suring tools and return the removed parts. 3 Oil pressure pickup plug: 20 – 27 Nm {2.0 – 2.8 kgm} Adjusting a The unload valve and safety-suction valve for lowering the boom cannot be adjusted. 5. Measuring swing relief pressure 1) Start the engine, set the working mode in the power mode (P), and turn the swing lock switch ON. 6. Run the engine at high idle, operate the left work equipment control lever to relieve the swing motor, and measure the oil pressure. a The pressure measured when the swing motor relief valve is relieved is indicated. a The swing relief pressure is lower than the main relief pressure. 1.

Adjusting work equipment and travel relief pressure a If the relief pressure of the work equip- ment circuit and travel circuit is abnormal, adjust main relief valves (3) and (4) according to the following procedure. q (4): Rear (R) main relief valve a When adjusting the main relief valves, remove the top cover of the control valve. a Adjust only the low relief pressure of the main relief valve. If the low repair proce- dure is adjusted, the high repair procedure is set automatically. a The low relief pressure is the pressure applied when the 2-stage relief solenoid valve is turned OFF and the pilot pressure is not applied to the selector port. q (3): Front (F) main relief valve 7.

Travel relief pressure 1) Run the engine and lock the travel mecha- nism. k Put pin [2] between the sprocket and track frame to lock the travel mechanism securely. 2) Set the working mode in the power mode (P). 3) Run the engine at high idle, operate the travel lever and pedal to relieve the travel motor, and measure the oil pressure. 1) Disconnect pilot hose (5). 2) While fixing holder (6), loosen locknut (7). 3) Turn holder (6) to adjust the set pressure. a If the holder is k Before operating the travel lever and pedal, check the position and locking direction of the locked sprocket again. q Turned to the right, the set pres- sure is increased.

q Turned to the left, the set pres- sure is decreased. a Quantity of adjustment per turn of holder: PC210, 230, 240-8 29